Saturday, June 8, 2019

1.5" Candle Holder

At my shop, we sell a line of pre-made spell candles that are 1.5" in diameter. These candles are hand made (not by me) and the bases are not perfectly flat. The odd diameter and the imperfect bottom make finding a holder for them a little challenging. To combat that problem, I have custom made some quick wooden block style holders designed especially for these candles.

The cat's name is Luna ;)

The holder is just a square block of solid walnut with rounded over edges and two holes drilled in it. I made the prototype batch of six holders in about an hour (not counting finish drying time).

I got walnut from the scrap bin at my favorite hardwood dealer. I just measured the width of the board and set a stop block to that same width to cut the blocks off at the chop saw. Then I found the center of the top and the front face. I used a 1.5" forstner bit to drill a hole in the top to accept the candle, and a 1-3/8" forstner bit to drill a shallow hole in the front face to accept a maple inlay cut on the laser (1.38" diameter, 0.18" thickness). The top and side edges were eased over with a 1/8" round over bit at the router table.

As it turns out, the little aluminum cups that tea lights come in fit perfectly into the top hole, and so that will protect the wood from the burning candle. Hopefully. Never leave a candle burning unattended, kids. Especially in a WOODEN candle holder!

The finishing was a bit of a hodge-podge. I started out using danish oil, but I didn't want to wait for multiple coats to dry, so after the first coat I switched to shellac. But even after two coats of shellac (and sanding in between) they didn't have a nice shine, so I then gave them a quick spray of clear lacquer from a rattle can. Maybe with the next batch I'll try just one or two coats of polyurethane.

No comments:

Post a Comment